CAUTION: Road Work Ahead

In a typical year, the state of Texas has more than 1,000 highway projects under contract. As a result, drivers are likely to encounter a variety of work zone conditions, including uneven pavement, narrow lanes, concrete barriers, slow moving equipment, and loose gravel.

About 100 people, most of them motorists, are killed in work zones across Texas each year.

If you’re traveling in Texas, here’s the law regarding driving in work zones:

Texas law requires you to obey all signs in work zones. Fines for moving violations can be as much as $400 in construction or maintenance work zones marked with signs indicating that fines double when workers are present. You should always see a “Begin . . .” sign at the start of such zones. Enforcement of rules while in the ‘zone’ ends when you see the “End . . .” sign. (Note: I have noticed that the wording on ‘zone’ signs sometimes varies. For instance, the ‘end’ sign may say, “End Road Work”, or “End Work Zone”. Regardless, you should look for and pay particular attention to where a construction or work zone begins and ends.)

TRAVEL TIPS:

• Plan ahead by checking the web at www.dot.state.tx.us for state construction sites where travel may be delayed.
• Allow extra travel time, and be patient. Reducing your speed from 60 miles per hour to 45 miles per hour in a two-mile work zone delays your journey by only ONE minute!
• Observe all work zone warning signs; and, pay attention to flaggers in orange vests directing traffic.
• Merge at the first notice of a lane closure or change.
• Keep a safe distance between your vehicle, other vehicles, traffic barriers, construction workers, and equipment. Extra caution is required when driving in an active work zone at night!
• Avoid distractions! Don’t use your cell phone or send text messages. Don’t fiddle with the radio controls or your MP3 player.

Drivers can get tickets or even go to jail for going too fast on the roads, but one local sheriff in Rogers, Arkansas was able to get off without being ticketed even after being pulled over for speeding.

Benton County Sheriff Keith Ferguson was pulled over for going too fast on May 1 at North Second and Easy streets in Rogers. He was going 60mph in a 35mph zone at around 1a.m. That was enough for Rogers police Officer Aaron Dildy to make a traffic stop.

Police dashcam video showed Ferguson producing his ID and registration just like anybody else. But Dildy only issued the sheriff a warning citation, which Ferguson actually refused to accept.

Ferguson told us he never identified himself as a police officer, so that couldn’t have influenced the traffic stop. Ferguson said, “If he would have wrote me a ticket I would have paid the ticket but I wasn’t going to ask him to write me a ticket.

Rogers Chief of Police Steve Hamilton told us the situation played out exactly like it should have. Hamilton said, “Receiving a warning is pretty much a standard practice. I think what an officer is looking for is compliance.”

This isn’t the first time this has happened. In 2006 Ferguson was pulled over by Bentonville police. That time Ferguson drove away from the officer before he was even told he could leave. Hamilton also said there’s a possibility Dildy didn’t know who Ferguson was at the time of the stop.

Hmmm… Driving 60 mph in a 35 mph zone at night warrants a warning?! Yea… Right!